![[Main Page]](/modules/mediawiki/images/mediawiki.png)
| Revision as of 15:21, 29 September 2014 (edit) pzebelloni (Talk | contribs) ← Previous diff |
Revision as of 15:29, 29 September 2014 (edit) pzebelloni (Talk | contribs) (→Software) Next diff → |
||
Line 80: |
Line 80: | ||
| == Software == | == Software == | ||
| - | A software utility will be available for download as an update will be available. | + | Since TI BSL may erase EEPROM Segment A, programming with standard utilities will brick One. |
| + | |||
| + | A dedicated software utility will be available for download together the first software update. | ||
Revision as of 15:29, 29 September 2014
Contents |
Hardware Requirements
A free USB port is required to update HardWaves devices.
Surfer
No additional hardware is required to update Surfer, since it connects directly on USB.
One - HW1
A USB-to-TTL UART cable is required.
A FTDI cable like TTL-232RG-VSW3V3-WE can be used, but requires a patch.
Using a sharp cutter, a part of plastic case has been removed, and brown wire has been moved on the pad shown in the image, between orange and green wires.
Any case, UART used signals are: RXD, TXD, RTS, DTR, GND and Power.
WARNING!!! A voltage of +3.3 [VDC] is required.
The image above shows HW1 Programming port. Odd pins ( #1, #3, #5) are in the bottom row, while even pins (#2, #4, #6) are in the top row.
Signals direction is indicated from the point of view of HW1 board.
| One PIN#
| Name
| Mode / Direction
| UART
| Remarks
|
|---|---|---|---|---|
| 1 | GND | Power | GND | Power & Signal Reference |
| 2 | /RST | IN | DTR | MSP RESET Signal |
| 3 | BSL_TX | OUT | RXD | TX Data (ONE -> Host/PC) |
| 4 | TEST | IN | RTS | MSP TEST Signal |
| 5 | BSL_RX | IN | TXD | TX Data (One <- Host/PC) |
| 6 | VDD | Power | +3V3 | +3.3 [VDC] Power Supply |
Software
Since TI BSL may erase EEPROM Segment A, programming with standard utilities will brick One.
A dedicated software utility will be available for download together the first software update.