Firmware Update
From C-Labs Home
Contents |
Hardware Requirements
A free USB port is required to update HardWaves devices.
Surfer
No additional hardware is required to update Surfer, since it directly connects to USB host port.
One - HW1
A USB-to-LVTTL UART cable is required.
A FTDI cable like TTL-232RG-VSW3V3-WE can be used, but requires a patch.
Using a sharp cutter, a part of plastic case has been removed, and brown wire has been moved on the pad shown in the image, between orange and green wires.
Any case, UART used signals are: RXD, TXD, RTS, DTR, GND and Power.
WARNING!!! A voltage of +3.3 [VDC] is required.
The image above shows HW1 Programming port. Odd pins ( #1, #3, #5) are in the bottom row, while even pins (#2, #4, #6) are in the top row.
Signals direction is indicated from the point of view of HW1 board.
| One PIN#
| Name
| Mode / Direction
| UART
| Remarks
|
|---|---|---|---|---|
| 1 | GND | Power | GND | Power & Signal Reference |
| 2 | /RST | IN | DTR | MSP RESET Signal |
| 3 | BSL_TX | OUT | RXD | TX Data (ONE -> Host/PC) |
| 4 | TEST | IN | RTS | MSP TEST Signal |
| 5 | BSL_RX | IN | TXD | TX Data (One <- Host/PC) |
| 6 | VDD | Power | +3V3 | +3.3 [VDC] Power Supply |
Software
Since TI BSL may erase EEPROM Segment A, programming with standard utilities will brick One.
A dedicated software utility will be available for download together the first software update.
